Speed & Feed Calculator
Calculate spindle speed, feed rate, chip load, and basic cutting conditions for milling, turning, drilling, grooving, and parting.
✓ Runs in your browser↔ Metric and inch unitsƒ Formula shown
01
Enter machining data
Default values are examples. Replace them with your actual setup data.
03
Formula and engineering notes
Formula / logic
Metric milling: RPM = 1000 × Vc / (π × D). Feed = RPM × teeth × chip load. Inch milling: RPM = 12 × SFM / (π × D).
Metric milling: RPM = 1000 × Vc / (π × D). Feed = RPM × teeth × chip load. Inch milling: RPM = 12 × SFM / (π × D).
Engineering disclaimer: these tools are for estimating and planning. Verify production parameters with toolmaker catalogs, machine limits, material data, and applicable standards.
Frequently asked questions
Can this result be used directly on a CNC machine?
Use it as a starting value only. Check the tool manufacturer data, machine limits, workholding, coolant and material condition before production.
Which units does the calculator support?
The calculator shows the units beside each input. Select metric or inch units where the page provides a unit-system control.
Why can shop results differ from the calculation?
Tool geometry, coating, runout, rigidity, chip evacuation, material hardness and machine power can change the practical result.